Find our Industrial Innovation department here (in Danish)

FAQ

Can your robot system profile both inside and outside circumferential/girth weld seams in a monopile or tower section?

Robotic profiling of inside and outside girth welds

Yes. The TM401 can perform automated weld profiling on both inside and outside girth/circumferential weld seams.

For inside seams, the robot is deployed inside the monopile or tower section itself. For outside seams, it operates either on the shop floor or from a dedicated elevation platform.

Selection between inside or outside girth/circumferential weld profiling is a one-click procedure performed in the robot control panel.

One robot system for internal and external circumferential weld profiling

Yes, the Maxars TM401 is designed to profile both inside and outside girth/circumferential weld seams in monopile foundations and tower sections, switching between the two with a one-click setup rather than requiring a different machine.

What changes between inside and outside operation is not the robot’s core technology. The same laser-guided sensing, servo and servo-hydraulic positioning, and single-pass machining to ±0.2 mm accuracy apply in both cases, but how the robot and machining tool are physically positioned and supported to reach the weld seam changes.

Inside girth weld profiling: deployment and seam-to-seam transfer

For inside circumferential welds, the TM401 is deployed inside the monopile or tower section itself. The robot is moved into position using its dedicated lifting yoke together with a fork-lift truck, with storage-to-section deployment and section-to-section transfer taking under 15 minutes and seam-to-seam transfer inside a section taking approximately 5 minutes.

Operating from the inside, the TM401 addresses same-thickness joints, thickness-transition joints, and the inside conical top joint, automatically compensating for plate offset of up to ±3 mm.

Outside girth weld configuration

For outside girth/circumferential welds, the TM401 is mounted and operated either on the shop floor or from a dedicated elevation platform — a movable or mobile platform solution purpose-built to raise the robot to weld-seam height on the exterior of a monopile or tower section.

This matters because monopile and tower sections are supported on roller beds during fabrication, often with headroom preserved underneath for self-propelled modular transporters (SPMTs) to manoeuvre.

The same single-pass, laser-guided profiling process applies once positioned.

One system, one performance envelope, two configurations

Because both configurations run the same underlying robot and control system, inside and outside weld profiling deliver the same productivity — 30-60 metres per hour, single-pass — and the same CNC-quality, repeatable geometry (large-radius toe transition, surface finish below Ra 3.2 µm) regardless of which side of the plate is being profiled.