TM401
Automate for repeatable quality, greater output, lower cost, and improved HSE
- Single-pass flush (large-radius) weld profiling of inside and outside girth welds in wind turbine support structures at a rate of 30-60 meters/hour
- Programmed and CNC-quality profiling and surface finish across weld geometries, including off-sets and thickness transitions
- Storage-to-seam deployment and section-to-section transfer in 15 minutes. Seam-to-seam transfer in 5 minutes
- Dust-free, low-noise and supervision-only operation
- The TM401 weld profiling robot system is field-proven and was developed in collaboration with monopile and tower producers in Europe.
- Replacing weld grinding with machining has been recognised by DNV as more advanced, with machining requiring removal of material only to 0.2 mm below undercuts (DNV-RP-C203 section 7.3.2).
Contact us
To inquire about our weld profiling robot technology and to book a demonstration in your monopile or tower production facility, please contact:
Project and Market Manager,
Morten Flatau
Telephone: +45 21 25 75 00
Mail: mf@maxars.com
CEO,
Claus Valsted
Telephone: +45 21 25 75 15
Mail: cv@maxars.com
Office hours are 8:00 AM to 4:00 PM (CET)